EPever 3210AN 12V/24V MPPT Battery Regulator Charge Controller with Ma – Temank

EPever 1210AN 12V/24V MPPT Battery Regulator Charger Controller with Max PV Input 100v for Solar home System Solar Charge Controller Brand: Temank Apllication: Solar home System, field monitoring, stations, etc Advanced MPPT technology
Solar Charge Controller Brand: Temank Apllication: Solar home System, field monitoring system, stations System, etc Advanced MPPT technology, with efficiency no less than 99.5% Ultra-fast tracking speed and guaranteed tracking efficiency Advanced MPPT control algorithm to minimize the maximum power point loss rate and loss time Wide MPP operating voltage range High quality components, perfecting system performance, with maximum conversion efficiency of 98% Accurate recognition and tracking of multiple-peaks maximum power point International famous brands of ST and IR's components of high quality and low failure rate are used, which can ensure the product’s service life Charging power and current limitation function Compatible with lead-acid and lithium-ion batteries Battery temperature compensation function Real-time energy statistics function Overheating power reduction function Multiple load work modes The communication port adopts professional protection chip, which can provide 5VDC power supply, and has over-current and short-circuit protection. With RS-485 communication bus interface and Modbus communication protocol, it is available to meet various communication requirements in different situations. Monitor and set the parameters via mobile phone APP or PC software Full-load operation without any drop in capacity within the range of working environment temperature Extensive electronic protection ★If the temperature sensor is short-circuited or damaged, the controller will charge or discharge at the default temperature setting of 25 ºC. Maximum Power Point Tracking Technology Due to the nonlinear characteristics of solar array, there is a maximum energy output point (Max Power Point) on its curve. Traditional controllers, with switch charging technology and PWM charging technology, can’t charge the battery at the maximum power point, so can’t harvest the maximum energy available from PV array, but the solar charge controller with Maximum Power Point Tracking (MPPT) Technology can lock on the point to harvest the maximum energy and deliver it to the battery. The MPPT algorithm of our company continuously compares and adjusts the operating points to attempt to locate the maximum power point of the array. The tracking process is fully automatic and does not need user adjustment. As the Figure 1-2, the curve is also the characteristic curve of the array, the MPPT technology will ‘boost’ the battery charge current through tracking the MPP. Assuming 100% conversion efficiency of the solar system, in that way, the following formula is established: Figure 1-2 is the maximum power point curve, the shaded area is charging range of traditional solar charge controller (PWM Charging Mode), it can obviously diagnose 3that the MPPT mode can improve the usage of the solar energy resource. According to our test, the MPPT controller can raise 20%-30% efficiency compared to the PWM controller. (Value may be fluctuant due to the influence of the ambient circumstance and energy loss.) In actual application, as shading from cloud, tree and snow, the panel maybe appear Multi-MPP, but in actually there is only one real Maximum Power Point. As the below Figure 1-3 shows: If the program works improperly after appearing Multi-MPP, the system will not work on the real max power point, which may waste most solar energy resources and seriously affect the normal operation of the system. The typical MPPT algorithm, designed by our company, can track the real MPP quickly and accurately, improve the utilization rate of the array and avoid the waste of resources. Battery Charging Stage The controller has a 3 stages battery charging algorithm (Bulk Charging, Constant Charging and Float Charging) for rapid, efficient, and safe battery charging. A) Bulk Charging In this stage, the battery voltage has not yet reached constant voltage (Equalize or Boost Voltage), the controller operates in constant current mode, delivering its maximum current to the batteries (MPPT Charging). B) Constant Charging When the battery voltage reaches the constant voltage setpoint, the controller will start to operate in constant charging mode, this process is no longer MPPT charging, and in the meantime the charging current will drop gradually, the process is not the MPPT charging. The Constant Charging has 2 stages, equalize and boost. These two stages are not carried out constantly in a full charge process to avoid too much gas precipitation or overheating of battery. There is detail information about 3210AN 12V/24V MPPT Battery Regulator Charger Controller

EPEVER Tracer 4210AN Series Negative Ground and compatible with Lithium(LiFePO4) Battery Charging. Compatible with 12V or 24V battery system. High

EPEVER 40A MPPT Solar Charge Controller 100V Input Tracer 4210AN with Display Negative Ground Lithium Battery Charger Work with LiFePO4

EPEVER 10A MPPT Solar Charge Controller 12/24V DC Tracer-an Series Charge Controller with MT50 Remote Meter &Temperature Sensor &RS485 fit for Lithium, Sealed, AGM Battery Charging Negative Grounded : Patio, Lawn & Garden

Note stock are the latest version of the controller! The main image is not change success! Battery Voltage: 12V/24V auto; Rated Charge & Discharge

Temank EPEVER Dual Battery Solar Charge Controller 20A 12V 24V Duo-Battery Solar Controller for RVs Caravans and Boats-New Version

Negative Ground Tracer AN series MPPT Controller: 12V/24V/36V/48V Auto identifying system voltage. Auto control system to limit the charging power

EPEVER 60A MPPT Charge Controller 48V 36V 24V 12V Auto, 60 amp Negative Ground Solar Controller MPPT Max 150V Input fit for Litium Sealed (AGM) Gel

EPEVER 30A MPPT Solar Charge Controller 12/24V DC Tracer-an Series Charge Controller with MT50 Remote Meter &Temperature Sensor &RS485 Cable fit for Lithium, Sealed, AGM Battery Negative Grounded : Patio

EPEVER MPPT Charge Controller 30A, Max PV 100V 12V/390W, 24V/780W, Negative Grounded, LCD Display Work for Lead-Acid Sealed /Gel(AGM)/Flooded and Lithium Battery Charging(MPPT 30A) : Patio, Lawn & Garden

Temank EPever MPPT Solar Charge Controller Tracer3215B Feature, Brand: Temank, Technology: MPPT, Advanced Maximum Power Point Tracking (MPPT)

Temank EPever MPPT Solar Charge Controller Tracer3215BN 30A 12V 24V DC

Temank EPever MPPT Solar Charge Controller Tracer 1215B 10A 12V 24V DC at best price from factory

Temank EPever MPPT Solar Charge Controller Tracer3215BN 30A 12V 24V DC

Negative Ground Charge Controller featuring advanced MPPT technology with high tracking efficiency up to 99.5% and peak conversion efficiency of 98%. Maximizing the energy from solar panels to charge your system. This MPPT Controller protection built-in against reverse polarity, overcharging, over-discharging, overload, short-circuiting, and reverse current. It protect the battery from being over-charged by the solar modules and over-discharged by the loads.