IPCamPower POE Combiner Splitter Adapter, Run 2 IP Cameras on 1 Cable IPCP-212X

* Allows you to run 1 cable run to the switch for 2 cameras that are near each other, saving on time and material costs. Set consists of a sender

4 Pack IPCamPower Mini PoE Injector Wall Wart Plug | 802.3at Full 30 Watts | Designed for IP Cameras

POE Combiner Splitter Adapter, Run 2 IP Cameras on 1 Cable

POE Splitter that works! : r/reolinkcam

* Can Serve 2 Purposes (or both at the same time): #1) Can be used as a POE powered 2 Port POE switch #2) Can be used to extend your network cable run

IPCamPower POE Powered 2 Port Switch & Network Cat5 Cat6 Midspan Cable Range Extender Passthrough Repeater for IP Cameras IPCP-EXT2P

PoE Combiner & Splitter for Security Cameras

POE Splitter that works! : r/reolinkcam

IPCP-212 PoE Combiner Splitter Adapter: Your Solution for Dual IP Cameras - Unboxing & Review - Pipl.System

Some of the most extreme weatherproof and ruggedized CAT5e Cable you will see on the market. Can withstand virtually all weather conditions. Can literally be installed directly in the ground and buried directly without any conduit needed. Gel Filled and Double Jacketed for Ultimate Moisture Protection. The inner conductors are protected by a tough black UV rated outer jacket. They are further protected by an even tougher inner gray jacket.

IPCamPower Cat5e Cable 1000 Gel Filled Direct Burial Double Jacketed Weatherproof Waterproof UV Rated Solid Copper, Easy Pull Box

IPCP-212 PoE Combiner Splitter Adapter: Your Solution for Dual IP Cameras - Unboxing & Review - Pipl.System

Ipcampower POE Combiner Splitter Adapter Run 2 IP Cameras on 1 Cable

Allows you to run 1 cable run to the switch for 2 cameras that are near each other, saving on time and material costs. Set consists of a sender Combiner unit and a receiver Splitter unit. Plug Combiner unit into 2 open ports on your POE switch or POE NVR. Run one long cable to the location that has the cameras that are nearby each other and plug it into the Splitter. Connect 2 short cables to the Splitter unit and connect the other ends to your camera. Done! Reduces cabling costs.