Free STL file Shelly H&T Case (external Power Supply) 🔧・3D printable model to download・Cults

This is a simple case for the Shelly H&T sensor. One Base is with mounting points for a step down module one is without them. Both come with a 4mm hole for a USB Cable. The Shelly H&T twists into the lid like in the original case As the Shelly H&T only is rated for 3V you should use some type of voltage regulator! additionaly needed:

• 4 2.9mm x 9mm screws for the lid
• 2 2.9mm x 6mm screws for the step down module if used
• USB Cable
• Voltage regulator / Step down Module

Free STL file Dual Power Supply External Case 🏠・3D printer model

shelly case 3D Models to Print - yeggi

shelly 3D Models to Print - yeggi - page 5

shelly case 3D Models to Print - yeggi

Free STL file Simple Power Supply 🔭・3D print model to download

shelly 3D Models to Print - yeggi - page 5

Shelly Case v2 + AddOn by wolf3D

9mm case by 3D Models to Print - yeggi - page 4

Shelly Case v2 + AddOn by wolf3D

9mm case by 3D Models to Print - yeggi - page 4

shelly em din rail 3D Models to Print - yeggi