No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC
My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the
Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF
Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF
Arduino Uno and Electrical Basics - Troubleshooting - V1 Engineering Forum
An Arduino Nano Electronic Speed Controller (ESC) — Part 2, by David Such
LMV358 (Uno R3) – possible partial damage from 12V PSU? - General Electronics - Arduino Forum
No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum
Arduino Uno Breadboard Tray By Sdhuk Download Free STL, 47% OFF
Stepper motor + Arduino Uno + CNC Shield + DRV8825 and it doesn't work - Motors, Mechanics, Power and CNC - Arduino Forum
GRBL Based CNC Controller Bundle with UNO R3 CNC Shield Power Supply 24V 350W, The DCcduino Uno is a micro-controller board based on the ATmega328
GRBL Controller Bundle With UNO R3 CNC Shield Power Supply