No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum

My son was using his Elegoo kit I got him. He had done lesson 3 (hardwire an LED), and was doing lesson 4 and could not get it to work. I then plugged in my Arduino Uno R3 to see if it was the Arduino. Same result. So I got out my volt meter, and I'm only getting a few millivolts between the V5 pin and GND. It's possible something was wrong with his circuit that fried the regulator on his board, and then when I plugged mine it it fried mine also? Anyway, I should always get +5 out of the

5v DC Motor and Arduino with the Same Power Supply - Motors, Mechanics, Power and CNC - Arduino Forum

Actuating A 5V Push/Pull Solenoid - Motors, Mechanics, Power and CNC - Arduino Forum

main@

Does the Arduino board break with this circuit ? - Motors, Mechanics, Power and CNC - Arduino Forum

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

Stepper motors not responding - Motors, Mechanics, Power and CNC - Arduino Forum

Need Help In Arduino Uno, L298N and Dc Motor - #13 - Motors, Mechanics, Power and CNC - Arduino Forum

Circuit Power Question - Motors, Mechanics, Power and CNC - Arduino Forum

No 5V+ from Arduino Uno R3 - Motors, Mechanics, Power and CNC - Arduino Forum

3.3V pin, Arduino UNO R3, doesn't work! - IDE 1.x - Arduino Forum

Getting more than 5v from the UNO 5v pin - Motors, Mechanics, Power and CNC - Arduino Forum

2 L9110s cannot run 4 motors simultaneously - Motors, Mechanics, Power and CNC - Arduino Forum

DC motors are not receiving power - Motors, Mechanics, Power and CNC - Arduino Forum

Continuity Issues with 5V 10A supply + LEDs - Motors, Mechanics, Power and CNC - Arduino Forum