Wemos D1 clone: digitalRead is unreliable - General Electronics - Arduino Forum
Hey there, not sure if it's the correct category, but I believe this is an electronic issue: I have two buttons hooked up to pin D3 and D4 of my Wemos D1 mini clone (these are the pull-up pins) that connect to GND when closed. Closing a button is supposed to change the direction of a motor through an ESC hooked to pin D0. I measured the voltage over D3 und D4 and GND and they're both nicely pulled up to 3.3V. However, the Motor is continuously changing directions (not very often but every 3-10
Attack On The Clones: A Review Of Two Common ESP8266 Mini D1
ESP8266 Home Control 2016
Wemos Arduino UNO Clone with WiFi
Arduino Based GSM/SMS Remote Control Unit : 16 Steps (with
Arduino Uno R3 Price in BD
Wemos D1 Mini With Multiplexer Solved Blynk Community, 52% OFF
wemos d1 mini - digitalRead true even when switch not activated
Autonomous SanitizerOnDemand Robot with OpenCV Navigation
Posts with «github» label