ste-gmd.com

sottoscrivi

Accedi

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint

Stringing with PETG. Sunlu filament printed at 240/90. Sliced with PrusaSlicer 2.3.1 using Generic PETG and 0.30mm DRAFT settings. Suggestions? : r/ FixMyPrint