220V safety control using relay module - General Electronics

Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void

In-Depth: Interface One Channel Relay Module with Arduino

SSR Solid State Relay Module 10-100 amp DC-DC 3-32V DC to 5-220V DC Heat Sink

DC-DC SSR Solid State Relay Input 3-32VDC Load 5-220VDC Control Relay

General Purpose Relay, Control Relays and Timers

Relay Switch Circuit and Relay Switching Circuit

433Mhz RF ON-OFF DC8-86V 30A Relay Wireless Remote Control Switch - DAIER

What is Relay? - Working, Applications & Types – Robocraze

What is a MOSFET Relay? OMRON Device ＆ Module Solutions - Americas

Relay Wiring Diagram, Relay Connection, Relay Working Principle

DC-DC SSR Solid State Relay Input 3-32VDC Load 5-220VDC Control Relay

The Basics of Control Relays, Relay Control Systems

1-Wire Eight Channel Relay Module for Home Automation with DIN BOX

How to use relay with arduino - Turn on and off 220V AC lamp