integrated circuit - Can I combine step-up and step-down designs for switched DC-DC convertor? - Electrical Engineering Stack Exchange

I need to generate 5 volts from unstable source. The voltage on input will be between 2 to 7 volts. The source is hand-crafted dynamo, which I'm doing as an experiment. I found LT1173CN8-5 DIP8

High gain DC/DC converter with continuous input current for renewable energy applications

dc dc converter - Vin: 2-36, Vout: 4.2. Should I use step-up, followed by step-down, or SEPIC? - Electrical Engineering Stack Exchange

Electronics, Free Full-Text

circuit analysis - Why is the flying capacitor voltage half of the input voltage in a 3-level buck converter? - Electrical Engineering Stack Exchange

Non-Isolated DC-DC Step-Down Converters with Integrated Inductors for Space-Constrained Applications

5V/2A Synchronous DC-DC Converter IC Evaluation Kit

Review of DC-DC Converter Topologies Based on Impedance Network with Wide Input Voltage Range and High Gain for Fuel Cell Vehicles

switch mode power supply - How to make a step down DC-DC converter fail safe? - Electrical Engineering Stack Exchange

soldering - How much current should a switching regulator consume on its own? - Electrical Engineering Stack Exchange

integrated circuit - Thermal relief for a chip without metal plate on the bottom - Electrical Engineering Stack Exchange

How does the simple circuit of a boost (step-up) DC-DC converter work? - Quora

Integrated Step-Down DC/DC Module Benefits

switch mode power supply - Why is it required to put an external inductor and diode at the output of a step-down switching voltage regulator? - Electrical Engineering Stack Exchange